 |
The smaller of the two cutouts
for the sparkplug wires. No cleanup on the hole has been done yet in
these pictures. |
 |
The larger of the two cutouts.
I probably could have made it a little more snug, but I'm sure vibration
would be an issue. I angle to sparkplug wire down a little so as not
to have to cut an overly long hole in the cowl. That is why the two holes
look different. |
 |
This picture shows how much
the sparkplug wire sticks out due to the engine offset. Even if the
engine had not been offset, the sparkplug wires would have rubbed the
inside of the cowl, so holes would be necessary anyway. |
 |
A cowl full of engine! I
will probably use the Dremel to open up the front vents just a hair more
to allow as much airflow as possible. |